Description :
Spray and Fuse Process
Spray and Fuse coatings has virtually no porosity and bond strength comparable to welding.
Process description
Coating material in a powder form is fed into an oxygen-fuel gas combustion flame, melted and projected by the gas stream onto a prepared substrate. This process requires a fusing process after being sprayed. This is done by using a torch to bring the part up to approximately 1100 degrees Centigrade.
HORIZONTAL TIG WELDING EQUIPMENT
This Equipment very useful for carrying narrow groove welding to join thick sleeves, long tubes and to carry cladding on large components. The welding principle of this equipment is Tungsten Inert Gas Welding (TIG) principle.
